Husqvarna Lawn Mower Owner's Manual

The Husqvarna Lawn Mower is a high-performance outdoor power tool designed for efficient and reliable lawn maintenance. It features a powerful engine, durable cutting deck, adjustable cutting height, ergonomic handles, and safety features like blade brake systems. Below are key sections for safety, features, assembly, operation, maintenance, and troubleshooting.

Features at a Glance

Key components: Engine, Cutting Deck, Handle Assembly, Height Adjustment Lever, Grass Collection Bag, Safety Key, and Starter Cord.

Assembly Instructions

Unpack and inspect all parts. Assemble on a flat, stable surface.

1. Attach the handle: Align handle brackets with deck mounts and secure with provided bolts.
2. Install the grass collection bag: Attach bag holder to rear discharge chute and hook bag onto holder.
3. Connect the control cables: Route throttle and drive control cables along handle as shown in diagram.
4. Install the safety key: Insert key into ignition slot until it clicks.
5. Add engine oil and fuel: Fill with recommended oil and unleaded gasoline.

WARNING! Always wear protective gloves during assembly. Ensure all fasteners are tightened securely.

First-Time Operation

Perform pre-operation checks before starting the engine.

1. Check oil level: Ensure oil is at the full mark on the dipstick.
2. Check fuel level: Fill tank with fresh, unleaded gasoline.
3. Adjust cutting height: Set lever to desired position (1-4).
4. Start the engine: Insert safety key, set throttle to choke, pull starter cord firmly.
5. Engage the blade: With engine running, pull blade engagement lever toward handle.
6. Begin mowing: Walk at a steady pace, overlapping each pass slightly.

CAUTION! Clear mowing area of stones, sticks, and debris before operation. Never mow on wet grass.

Specifications

• Engine Type: 4-cycle, single-cylinder gasoline engine.
• Engine Displacement: 160cc (model dependent).
• Cutting Width: 21 inches.
• Cutting Height Range: 1.5 to 4 inches (adjustable in 0.5-inch increments).
• Drive System: Self-propelled rear-wheel drive (select models).
• Fuel Capacity: 0.5 gallons.
• Oil Capacity: 20 oz. (SAE 30 recommended).
• Weight: Approximately 65 lbs.
• Warranty: Limited 2-year consumer warranty.

Controls and Settings

Primary controls located on the handle for easy access.

Handle Controls: Throttle Lever, Blade Engagement Lever, Drive Control Lever (self-propelled models), Height Adjustment Lever, and Safety Key.

Operation: Set throttle to FAST for mowing, SLOW for idling. Pull blade lever toward handle to engage cutting blade. Squeeze drive control lever to engage self-propulsion. Adjust cutting height via lever before mowing. Always remove safety key when not in use.

Cutting Height Adjustment

Adjust all wheels simultaneously with the single lever.

1. Stop the engine and wait for blade to stop completely.
2. Pull the height adjustment lever outward to disengage.
3. Move lever to desired setting (1=Lowest, 4=Highest).
4. Release lever to lock into position.
5. Check that all wheels are at the same height.

Tip: For a healthier lawn, never cut more than 1/3 of the grass blade length at one time.

Maintenance Schedule

Regular maintenance ensures optimal performance and longevity.

WARNING! Always disconnect spark plug wire before performing any maintenance.

Safety Features

Blade Brake Clutch (BBC): Stops blade within 3 seconds when handle is released. Safety Key: Must be inserted for engine to start. Operator Presence Control: Engine stops if operator leaves position.

Storage & Winterization

Prepare mower for long-term storage, especially over winter.

1. Clean thoroughly: Remove all grass and debris from deck and undercarriage.
2. Drain or stabilize fuel: Run engine until fuel tank is empty, or add fuel stabilizer.
3. Change oil: Replace with fresh oil to remove contaminants.
4. Remove spark plug: Add a teaspoon of oil into cylinder and pull starter cord slowly.
5. Store properly: Keep in a dry, covered area, preferably off the ground.

CAUTION! Never store mower with fuel in tank in an enclosed area due to fire risk.

Regulatory Information

EPA Certified: Engine meets EPA emission standards for outdoor power equipment. CARB Compliant: Meets California Air Resources Board requirements. For safety and emission compliance, use original Husqvarna parts only. Copyright © 2025 Husqvarna; trademarks of Husqvarna AB. For support, visit www.husqvarna.com or contact 1-800-HUSKY-62.

Troubleshooting

Service: 1-800-HUSKY-62; www.husqvarna.com