Husqvarna Mower 7021P Owner's Manual

The Husqvarna Mower 7021P is a robust, self-propelled walk-behind lawn mower designed for residential use. It features a powerful Briggs & Stratton engine, 21-inch steel cutting deck, 3-in-1 cutting system (mulch, bag, side discharge), single-lever height adjustment, rear-wheel drive with variable speed control, and easy-start technology. This manual covers safety instructions, assembly, operation, maintenance, troubleshooting, and specifications to ensure optimal performance and longevity of your mower.

Features at a Glance

Key components: Briggs & Stratton 140cc engine, 21-inch steel deck, rear bagger, mulch plug, side discharge chute, single-lever height adjuster, variable speed drive control, and easy-start system.

Assembly Instructions

Unpack all parts and inspect for damage. Assembly requires basic tools (included).

1. Attach handle: Align lower handle with deck brackets, secure with provided bolts and wing nuts.
2. Install upper handle: Connect to lower handle, tighten knobs.
3. Attach grass bag: Slide bag frame onto rear deck hooks; ensure bag is securely fastened.
4. Install side discharge chute (if not mulching): Snap into place on right side of deck.
5. Insert mulch plug (if mulching): Place plug into rear discharge opening.
6. Check wheel height: Adjust single lever to desired setting.
7. Add oil and fuel: Refer to engine manual for type and capacity.

WARNING! Always wear gloves during assembly. Ensure all fasteners are tight before operation.

Safety Information

Read and understand all safety instructions before operating.

1. Clear mowing area of stones, toys, and other objects that could be thrown.
2. Always wear sturdy footwear and eye protection.
3. Do not mow wet grass or in poor light conditions.
4. Never allow children or pets in area while mowing.
5. Disconnect spark plug wire before performing any maintenance.
6. Use extreme caution when mowing on slopes; mow across slopes, not up and down.
7. Never leave mower unattended with engine running.
8. Stop engine and wait for blades to stop before crossing gravel drives or roads.

DANGER! Rotating blades can cause severe injury. Keep hands and feet away from deck at all times.

Specifications

• Model: Husqvarna 7021P
• Engine: Briggs & Stratton 140cc, 4-cycle, OHV
• Cutting Width: 21 inches
• Cutting Height: 1.5 - 3.75 inches (6 positions)
• Cutting Options: Mulch, Bag, Side Discharge
• Drive: Self-propelled, rear-wheel, variable speed
• Speed Range: 0-3.5 mph
• Wheels: 8-inch rear, 7-inch front
• Fuel Capacity: 0.5 gallon
• Oil Capacity: 20 oz (SAE 30 recommended)
• Weight: 65 lbs (approx.)
• Warranty: 2-year limited

Controls and Operation

Handle Controls: Drive control lever (squeeze to engage drive), speed control dial, height adjustment lever, engine stop lever.

Starting: 1. Check oil and fuel. 2. Push primer bulb 3 times (cold engine). 3. Set throttle to FAST. 4. Pull recoil starter firmly. Stopping: Release drive lever, move throttle to STOP, wait for blades to stop.

Self-Propelled Operation: Squeeze drive lever to handle to engage wheels; adjust speed with dial. Mowing Tips: Overlap passes by 2-3 inches. Change mowing pattern weekly. Never cut more than 1/3 of grass height at once.

Cutting System & Height Adjustment

3-in-1 System: Configure for desired result.

1. Mulching: Install mulch plug. Cuts clippings finely and returns to lawn.
2. Bagging: Attach grass bag. Collects clippings for disposal.
3. Side Discharge: Install chute. Discharges clippings to side (for tall/wet grass).

Height Adjustment: Use single lever to set all wheels simultaneously. 6 positions from 1.5" (low) to 3.75" (high). Adjust based on grass type and season.

Tip: For best results, keep blades sharp and deck clean.

Maintenance Schedule

CAUTION! Always disconnect spark plug before any maintenance.

Engine Care

Briggs & Stratton 140cc Engine Maintenance:

1. Oil: Check level before each use. Change every 50 hours or season. Use SAE 30 detergent oil.
2. Air Filter: Clean foam pre-cleaner every 5 hours; replace paper element if dirty.
3. Spark Plug: Clean/gap (0.030") every 25 hours; replace annually.
4. Fuel: Use fresh unleaded gasoline (87 octane min). Add fuel stabilizer for storage.
5. Cooling System: Keep fins and cooling areas clean of grass and debris.

WARNING! Engine parts are hot during/after operation. Allow to cool before servicing.

Storage & Winterization

Proper storage extends mower life.

1. Clean thoroughly: Remove all grass, dirt, and debris from deck, engine, and wheels.
2. Fuel system: Add fuel stabilizer, run engine 5 minutes, then either drain tank or fill completely.
3. Oil: Change oil if due.
4. Spark plug: Remove, add 1 tbsp oil to cylinder, pull starter slowly to coat, reinstall plug.
5. Battery (if electric start): Remove and store fully charged in cool, dry place.
6. Store in dry, covered area, preferably off concrete floor.

CAUTION! Never store with fuel in tank without stabilizer. Gasoline degrades over time.

Warranty Information

Husqvarna 7021P comes with a 2-year limited warranty covering defects in materials and workmanship under normal residential use. Warranty does not cover wear items (blades, belts, tires), damage from misuse, neglect, improper maintenance, or commercial use. Proof of purchase required. For warranty service, contact an authorized Husqvarna service dealer or call 1-800-487-5962. Register your product online at www.husqvarna.com for faster service.

Troubleshooting

Service: For repairs beyond basic maintenance, contact authorized Husqvarna dealer or 1-800-487-5962.

Parts: Use only genuine Husqvarna replacement parts.