Husqvarna Mower LGT 2654 Owners Manual

The Husqvarna LGT 2654 is a 26-horsepower, 54-inch cutting width lawn and garden tractor designed for residential use. It features a Kohler Command Pro engine, hydrostatic transmission, electric PTO engagement, cruise control, comfortable high-back seat, headlights, and a durable steel frame. Below are key sections for safety, features, operation, maintenance, and troubleshooting.

1. Features at a Glance 2. Assembly & Setup 3. Controls & Operation 4. Specifications 5. Maintenance Schedule 6. Engine Care 7. Mower Deck Maintenance 8. Transmission & Drive System 9. Storage & Winterization 10. Safety Information 11. Troubleshooting

Features at a Glance

Key components: 26 HP Kohler Command Pro engine, 54-inch fabricated mower deck, Hydrostatic transmission, Electric PTO, Cruise control, Headlights, Hour meter, Cup holder.

Feature	Description
Engine	26 HP Kohler Command Pro, OHV, air-cooled
Cutting Width	54-inch fabricated steel deck
Transmission	Hydrostatic, infinite forward/reverse speeds
PTO Engagement	Electric clutch, dash-mounted switch
Steering	Power steering
Seat	High-back, adjustable, with armrests
Fuel Capacity	3.5 gallons
Headlights	Two front headlights for low-light operation
Hour Meter	Tracks engine hours for maintenance
Deck Lift	Manual or electric (depending on model)

Assembly & Setup

Unpack and inspect all parts. Assembly requires basic tools.

Install steering wheel: Align splines and secure with provided nut.
Attach seat: Mount seat onto frame using bolts and washers.
Connect battery: Attach red (+) then black (-) cables; ensure secure.
Check tire pressure: Inflate all tires to recommended PSI (see sidewall).
Add engine oil and fuel: Use specified types (see Specifications).

WARNING! Tractor is heavy; use assistance during assembly. Keep hands clear of moving parts.

Controls & Operation

Familiarize yourself with all controls before starting.

Starting: Sit on seat, set parking brake, move PTO to OFF, turn key to START.
Driving: Release parking brake, press brake pedal to disengage transmission lock, use forward/reverse pedals.
Mowing: Engage PTO switch at desired engine RPM, lower deck to cutting height.
Stopping: Disengage PTO, set parking brake, turn key to OFF.

CAUTION! Always engage parking brake on slopes. Do not mow on slopes greater than 15 degrees.

Specifications

Engine: Kohler Command Pro, 26 HP, 4-cycle, air-cooled.
Fuel Type: Unleaded gasoline, 87 octane minimum.
Transmission: Hydrostatic, infinite speed range.
Cutting Deck: 54-inch fabricated, 3-blade.
Cutting Height: 1.5 to 4.5 inches (adjustable).
Tire Size: Front 15x6.00-6, Rear 20x10.00-8.
Weight: Approximately 650 lbs (without attachments).
Dimensions: Length 72 inches, Width 64 inches, Height 42 inches.
Warranty: 2-year limited warranty.

Maintenance Schedule

Regular maintenance ensures longevity and performance.

Interval	Task
Before each use	Check engine oil, tire pressure, fuel level
Every 8 hours	Check mower deck for debris, inspect blades
Every 50 hours	Change engine oil, check air filter
Every 100 hours	Replace air filter, check spark plug
Every 200 hours	Change transmission fluid, inspect belts
Seasonally	Sharpen blades, grease fittings, check battery

Engine Care

Proper engine maintenance is critical for reliable operation.

Oil Change: Use SAE 10W-30, capacity 2 quarts. Change when warm.
Air Filter: Clean foam pre-cleaner every 25 hours; replace paper element as needed.
Spark Plug: Gap 0.030 inches; replace annually or every 100 hours.
Fuel System: Use fresh fuel; add stabilizer for storage over 30 days.

Tip: Always disconnect spark plug wire before performing maintenance.

Mower Deck Maintenance

Keep deck clean and blades sharp for optimal cutting.

Blade Sharpening: Remove deck, secure blade, file at original angle.
Belt Inspection: Check for cracks/wear; adjust tension if loose.
Deck Cleaning: Remove grass buildup after each use to prevent rust.
Height Adjustment: Ensure all wheels are at same setting for even cut.

WARNING! Wear gloves when handling blades. Ensure deck is securely supported.

Transmission & Drive System

Hydrostatic transmission requires periodic fluid checks.

Check fluid level with dipstick (clean area first). Use only specified fluid. If transmission slips or noise occurs, check fluid level and belt tension. Lubricate axle spindles and pivot points every 50 hours with general-purpose grease.

Storage & Winterization

Prepare tractor for off-season storage.

Fuel: Add stabilizer, run engine 10 minutes, or drain tank completely.
Battery: Disconnect, clean terminals, store in cool, dry place.
Engine: Change oil, remove spark plug, add teaspoon of oil to cylinder.
Deck: Clean thoroughly, apply light oil to prevent rust.
Store: In dry location, cover with breathable material.

CAUTION! Do not store with fuel in carburetor without stabilizer.

Safety Information

Always follow safety guidelines to prevent injury.

Read manual completely before operation.
Clear mowing area of debris, rocks, and toys.
Never carry passengers.
Wear sturdy shoes, eye protection, and hearing protection.
Stop engine before unclogging deck or adjusting components.
Use ROPS (Roll-Over Protective Structure) if equipped.
Keep hands and feet away from moving parts.
Do not operate on steep slopes.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Engine won't start	No fuel, bad spark, safety switch	Check fuel, spark plug, ensure PTO off and brake set.
Poor cutting performance	Dull blades, low engine RPM	Sharpen blades, check throttle setting, clean deck.
Excessive vibration	Unbalanced blade, loose parts	Inspect blade for damage, tighten bolts, check spindle.
Transmission slips	Low fluid, worn belt	Check fluid level, inspect drive belt for wear.
Battery won't charge	Loose connections, bad alternator	Clean terminals, check voltage regulator, test alternator.

Service: For repairs beyond basic maintenance, contact authorized Husqvarna dealer.

Support: 1-800-487-5952; www.husqvarna.com