Husqvarna Riding Mower TS 242XD Owners Manual

The Husqvarna TS 242XD is a 24-horsepower, 42-inch cutting deck riding lawn mower featuring a Kohler Courage twin-cylinder engine, hydrostatic transmission with cruise control, electric PTO engagement, adjustable cutting height (1.5-4 inches), dual-lever deck lift, comfortable high-back seat, headlights, cup holder, and 3-gallon fuel tank. Below are key sections for safety, features, assembly, operation, maintenance, and troubleshooting.

1. Features at a Glance 2. Assembly & Setup 3. Controls & Operation 4. Specifications 5. Maintenance Schedule 6. Cutting Deck Adjustment 7. Storage & Winterization 8. Safety Information 9. Warranty Information 10. Troubleshooting

Features at a Glance

Key components: 24 HP Kohler Courage engine, 42-inch stamped steel deck, Hydrostatic transmission, Electric PTO, Cruise control, High-back seat, Headlights, Cup holder.

Feature	Description
Engine	24 HP Kohler Courage twin-cylinder, overhead valve
Cutting Width	42 inches
Transmission	Hydrostatic, single pedal control
PTO Engagement	Electric switch
Cruise Control	Maintains speed without holding pedal
Cutting Height	Adjustable 1.5-4 inches (6 positions)
Deck Lift	Dual-lever system
Fuel Capacity	3 gallons
Seat	High-back, adjustable
Headlights	For low-light operation

Assembly & Setup

Unpack and inspect all parts. Assembly required for steering wheel, seat, and cutting deck.

Install steering wheel: Align and tighten with provided hardware.
Attach seat: Mount using bolts and washers; adjust position.
Install cutting deck: Lower deck lift, align with mounting points, secure with pins.
Check tire pressure: Inflate to 10-12 PSI.
Add engine oil: Use SAE 10W-30 (approx. 2 quarts).
Add fuel: Use fresh unleaded gasoline (87 octane or higher).

WARNING! Always disconnect spark plug wire before performing any assembly or maintenance.

Controls & Operation

Familiarize yourself with all controls before starting.

Starting: Sit on seat, set parking brake, move PTO to OFF, turn key to START.
Driving: Release parking brake, press forward/reverse pedal gently.
Engaging blades: Move PTO switch to ON position.
Adjusting speed: Use cruise control lever to set desired speed.
Stopping: Move PTO to OFF, engage parking brake, turn key to OFF.

CAUTION! Never operate on slopes greater than 15 degrees. Always mow across slopes, not up and down.

Specifications

Engine: Kohler Courage SV730, 24 HP, twin-cylinder, OHV.
Cutting Deck: 42-inch stamped steel, 2-blade system.
Transmission: Hydrostatic, infinite forward/reverse speeds.
Cutting Height: 1.5-4 inches (6 positions).
Fuel Type: Unleaded gasoline (87 octane minimum).
Fuel Capacity: 3 gallons.
Oil Capacity: 2 quarts (SAE 10W-30).
Turning Radius: 18 inches.
Weight: 550 lbs (approximate).
Warranty: 3-year limited warranty.

Maintenance Schedule

Regular maintenance ensures optimal performance and longevity.

Interval	Task
Before each use	Check tire pressure, fuel level, deck for debris
First 5 hours	Change engine oil (break-in period)
Every 50 hours	Change engine oil and filter
Every 100 hours	Replace air filter, spark plugs
Every season	Sharpen blades, check belt tension, grease fittings
Storage	Add fuel stabilizer, clean deck, remove battery

Tip: Always refer to engine manual for specific maintenance requirements.

Cutting Deck Adjustment

Proper deck adjustment ensures even cutting.

Park on level surface, set cutting height to middle position.
Measure distance from blade tips to ground at all four corners.
Adjust deck leveling rods to achieve 1/8-inch lower at front than rear.
Check belt tension: Should deflect 1/2 inch under moderate pressure.
Sharpen blades: Remove blades, sharpen at 30-degree angle, balance before reinstalling.

WARNING! Always disconnect spark plug wire before working under deck.

Storage & Winterization

Proper storage prevents fuel system damage and corrosion.

Add fuel stabilizer to tank and run engine for 5 minutes.
Change engine oil and filter.
Clean underside of deck thoroughly.
Remove battery and store in cool, dry place (keep charged).
Cover mower with breathable cover.
Store in dry, protected area.

CAUTION! Never store with gasoline in carburetor without stabilizer.

Safety Information

Read and understand all safety instructions before operation.

Always wear eye protection, long pants, and sturdy shoes.
Clear mowing area of debris, rocks, and toys.
Never carry passengers.
Do not mow when grass is wet.
Keep hands and feet away from moving parts.
Use extreme caution on slopes and uneven terrain.
Never leave mower unattended with engine running.
Keep children and pets away from mowing area.

DANGER! Rotating blades can cause serious injury or death. Always disengage PTO before leaving operator position.

Warranty Information

Husqvarna TS 242XD comes with 3-year limited warranty covering defects in materials and workmanship. Warranty does not cover normal wear, improper maintenance, accident damage, or commercial use. Keep original receipt for warranty claims. For warranty service, contact authorized Husqvarna dealer with model and serial numbers (located on frame behind seat).

Troubleshooting

Symptom	Possible Cause	Corrective Action
Engine won't start	Parking brake not set, PTO engaged, dead battery	Set parking brake, disengage PTO, charge/replace battery
Poor cutting performance	Dull blades, deck clogged, incorrect height	Sharpen blades, clean deck, adjust cutting height
Excessive vibration	Unbalanced blades, loose components	Balance or replace blades, tighten bolts
Loss of power	Clogged air filter, old fuel, dirty spark plugs	Replace air filter, use fresh fuel, clean/replace plugs
Hydrostatic transmission issues	Low fluid, drive belt worn	Check fluid level, inspect/replace drive belt
Uneven cutting	Deck not level, tire pressure uneven	Level deck, adjust tire pressure to 10-12 PSI

Service: For technical support, contact Husqvarna at 1-800-487-5962 or visit www.husqvarna.com