yth24v48 husqvarna lawn tractor manual

The YTH24V48 Husqvarna Lawn Tractor is a 24-horsepower, 48-inch cutting width riding mower featuring a V-twin engine, hydrostatic transmission, electric PTO engagement, cruise control, ergonomic high-back seat, headlights, cup holder, and a durable steel frame. It is designed for residential lawn care with enhanced comfort and cutting performance. Below are key sections for safety, features, operation, maintenance, and troubleshooting.

Features at a Glance

Key components: 24 HP Briggs & Stratton V-twin engine, 48-inch fabricated steel cutting deck, Hydrostatic transmission, Electric PTO clutch, Cruise control, Headlights, High-back seat, Cup holder, 12V battery, Fuel tank (2.5 gal).

Assembly & Setup

Unpack and inspect all parts. Assembly requires basic tools.

1. Install steering wheel: Align and tighten bolt.
2. Attach seat: Mount using provided bolts and washers.
3. Connect battery: Attach red (+) then black (-) terminals.
4. Add engine oil: Use SAE 30 or 10W-30, check dipstick.
5. Fill fuel tank: Use fresh unleaded gasoline (87 octane min).
6. Check tire pressure: Inflate to 14 PSI (front) and 10 PSI (rear).

WARNING! Keep hands clear of moving parts during assembly. Ensure all bolts are tightened securely.

Controls & Operation

Familiarize yourself with controls before starting.

1. Starting: Sit on seat, set parking brake, move PTO to OFF, turn key to START.
2. Driving: Release parking brake, use forward/reverse pedals for speed/direction.
3. Mowing: Engage PTO switch to lower and spin blades.
4. Cutting height: Adjust lever to desired setting (1.5-4 inches).
5. Stopping: Disengage PTO, set parking brake, turn key to OFF.

CAUTION! Do not operate on slopes greater than 15 degrees. Always look behind when backing up.

Specifications

• Engine: 24 HP Briggs & Stratton V-twin, OHV.
• Cutting Deck: 48-inch fabricated steel, 3 blades.
• Transmission: Hydrostatic, infinite forward/reverse.
• Fuel Capacity: 2.5 gallons.
• Cutting Height: 1.5 to 4 inches (adjustable).
• Turning Radius: 18 inches.
• Weight: 540 lbs (approx).
• Warranty: 2-year limited warranty.

Maintenance Schedule

Regular maintenance ensures longevity and performance.

Tip: Use only Husqvarna recommended parts and fluids.

Cutting Deck Adjustment

Proper deck leveling ensures even cut.

1. Park on level surface, set cutting height to middle position.
2. Measure blade tip height on both sides; adjust lift links to level.
3. Check front-to-back pitch (slightly lower in front).
4. Tighten all adjustment nuts securely after leveling.

WARNING! Disconnect spark plug wire before adjusting or servicing deck.

Storage & Winterization

Prepare tractor for off-season storage.

1. Add fuel stabilizer to tank, run engine for 5 minutes.
2. Change engine oil and filter.
3. Remove battery, store in cool dry place, charge monthly.
4. Clean deck thoroughly, apply light oil to blades.
5. Store in dry, covered location.

CAUTION! Never store with fuel in tank without stabilizer. Keep away from open flames.

Safety Information

Read and follow all safety instructions.

• Wear eye protection, sturdy shoes, and long pants.
• Keep hands and feet away from moving parts.
• Clear mowing area of debris before operation.
• Do not carry passengers.
• Do not mow on wet grass or steep slopes.
• Engage parking brake before dismounting.

DANGER! Rotating blades can cause severe injury. Always disengage PTO and turn off engine before leaving seat.

Warranty & Support

2-year limited warranty for residential use. Warranty covers defects in materials/workmanship. Not covered: normal wear, improper maintenance, commercial use. For support, visit www.husqvarna.com or contact 1-800-487-5962. Have model and serial numbers ready (located on frame near right rear wheel).

Troubleshooting

Reset: Disconnect battery for 5 minutes to reset electrical system if needed.

Service: 1-800-487-5962; www.husqvarna.com